...chain. The saw has an oil volume adjustment screw on the lower part of the case near the chain return area. Turning it CCW should increase oil flow. Oil volume can be judged by running the saw tip at ...
2 cycle engine oil most times , this bar chain oil most times is a 30W oil , if you change weights of oil then oil pump is not gonna add proper amount of oil to saw in use ,this will cause u problems
...chain saw 10532 do not functioning which caused the chain bar to running dry. I get asked this question a lot , im gonna have to make a video on this subject someday . but here: 1st ck your oil ...
...cause for bar, chain, and sprocket wear is lack of lubrication. There are several caused for this. First is just normal wear but many users suffer from premature wear because they use inferior oil. ...
Question about Makita Garden
...chain on saw groove and oil hole are clear oil in tank Sometimes saw dust and shavings block the oil port and track strip down the bar and chain there maybe a cover over the oil port remove this and ...
Question about Stihl Garden
...chain can cause the bar to heat up and expand, further tightening the chain. A properly adjusted Stihl saw will use almost all of the chain oil in the reservoir for every tank of gas. Too much oil is ...
...at a clean peice of timber, you should see a good line of oil spray from the tip of the bar onto the timber. Very dirty or dusty timber will also dry the oil out on the chain, and cause chain
...chain oil in case when not in use. if you store it somewhere other than a climate controlled building , the changes in temperature can cause the oil to expand out of the saw a little each time the ...
...saw mill where it is my job to keep chain saws running, learned years ago that you cannot use "bar oil" in winter. Need thinner oil, like motor oil. ....preferably a "non-detergent" motor oil, plain ...
202 questions posted
Usually answered in minutes!
778 Questions
129 Questions
92 Questions
66 Questions
77 Questions