Troy-Bilt 4-Cycle Curve Shaft Gas String Trimmer #41ADT41C966 "string trimmer adjust" Questions

...string trimmer. Cannot figure out how to get to magneto to adjust the gap without taking the whole engine apart. That is it. It is about that way for anything in the area of the clutch and flywheel. ...

...String Trimmer Starts Then Stalls http://support.mtdproducts.com/app/answers/detail/a_id/10666/~/basic-troubleshooting---handheld-string-trimmers-(gasoline-powered) Toro String Trimmer Starts Then ...

...string trimmer will not run How to fix a model#358.791510 string trimmer? It will run on half choke but not with choke off. I have checked fuel lines, air filter & carburater screws, also checked ...

...string trimmer won't rev up. Carbons up badly. Manual says take in to authorized deal for carb adjustment. With only an idle speed adjustment available, what card adjustment can be done? change spark ...

My TB475ss starts and dies right away When I pull my trigger for my string trimer it stays on for a few seconds and then it dies. carb is out of adjustment or gummed up

STIHL ENGINE REPAIR PROCEDURE FOR ENGINE -HARD TO START & RUNS POORE Start with adjusting the high and low side adjustment out 1 full turn, then adjust the idle.

...string trimmer will not rev up idles fine and starts up easy The fuel mixture and or idle speed may need adjustment. If yours is a newer trimmer and it has a two cycle engine, these adjustments are ...

poulan p2500 carb adjustment wont stay running in run position bogs down when accelarting Carb not set correctly. Screw down idle an fast run screws an then reset. Sometimes fuel gets clogged an needs

how do you adjust a walbro carbeurator if it is a fairly late model you will need a carburator adjusting tool.you can get them on ebay then set each screw at about two turns and fine tune from there

...string trimmer - needs idle adjust but there are no visible idle screws- special tool? yes, but on some you can use a small straight screwdriver, look 4 to red looking caps, that will be the high and ...