Troy-Bilt 4-Cycle Curve Shaft Gas String Trimmer #41ADT41C966 "rewind string" Questions

...string it I took it apart and not sure how to do it If you have the starter spool out (the one the rope goes in)...Here is what to do. Take the starter spool and change the rope out putting it back ...

Too much string comes out. I tried to rewind string (pushed it back in) but the same amount came out. Hello. Just pushing it back does not fix it. Cut off the excess and then you should be ok again. J

...pull string will not retract. I have repaired and continue to have problems. Is there a trick to rewinding the string? Do you have mfg instructions? Can be very tricky without following ...

...string trimmer binding flywheel and cord rewind during reassembly rewind works fine until reassembly as you put it together, pull the handle a bit so the recoil starter fingers fit into the flywheel ...

...rewind the string on the black and deckder grasshog how do you reload the double string It's annoying I know, but there should be a little notch in the spool, wind the string evenly round one groove. ...

...rewind my 26cc string trimmer model UT21509 will rewind the starter pull cord. I have taken mechanism apart for inspection and reassembled. Works okay without the shaft being attached. Not after one ...

...seem to figure out for sure the model # or # on the string? Most line trimmers will take .065 line. you can get this at lowes or home depot. Be sure to rewind it in the direction shown on the

troy-bilt trimmer TB 490 BC how do you rewind the string on the trimmer troy-bilt TB 490 BC Turn the bump knob clockwise to loosen on my tb490bc.

how do you get the starter string to rewind after it has been replaced Did you preload the Spring before tying the string back on>

...string wont go back in The rewind is sticking due to congealed grease, take the rewind off (as a complete unit) soak in hot strong soapy water pulling the string in and out to help flush the dirty ...