...do I force left or right turn? All the trimmers/gras cutters have blades rotating clockwise. So, to loosen, you have to turn the bolt left. If too thight - use WD-40 Spray. It puts some grease
...GAS WEED TRIMMER RIPCORD GOT TANGLED INSIDE THE MOTOR, WHAT DO I DO NOW? You should be able to take the housing loose with about 4-6 torx head bolts/screws and get in there and untangle the rope. May ...
Can not get the Bolt out of the bottem Spool to get off It is likely left hand or reverse threaded. You have to turn it the opposite way to loosen.
...gas, and CHOKE IN PROPER POSITION, my trimmer (purchased 10/9/2004) still hesitates and then stalls. Cannot rev it up. Is this a frequent problem? Can I fix it myself? Warren Besch ...
...up. Remember before taking anything apart use either PB blaster or Deep Creep on the bolts before loosening them. ...
...gas/oil mix on the plug or in the cylinder. Also, make sure the air filter is clean Try to make sure all bolts and screws are tight as lots of vibrations can loosen some of them.. An air leak on the ...
aHOW TO SET AIR GAP ON TB 70 SS The Torx head screws holding the coil in place have to be loosened. They may be tough as sometimes when assembled, the factory uses Threadlocker on them (alongwith the ...
...loosen the bump and feed cover. Seems like the bolt built into the cover may have been previously overtightened. How can I get this loose? Dis not get a manual so I'm not sure if this model has a ...
another one a little deeper in then get your wrench on the bolt and it may have reverse threads, so you have to turn counterclockwise to loosen . let me know if you have any problem or this isnt right
...go into. mine slide down a bit and the inside cables didn't engage. loosen the bolt on top and slide it back up. then secure bold again. if it keeps happening it is only a $6 or $7 dollar
161 questions posted
Usually answered in minutes!
623 Questions
420 Questions
215 Questions
193 Questions
