Husqvarna Forest & Garden 125c 17" Curvgastrimmer "starter cord stuck" Questions

...starter cord? You have to disassemble the unit to that point and then get the old cord out. Then you have to pre -load tension on the spring for the recoil unit by winding it (the plastic pulley) and ...

After turning of engine. Starter pull cord stuck. The recoil spring that rewinds the cord may have broken of pulled loose from its mooring.

...cord, you have to remove the starter housing. ... Swivel each plate until it locks into position and then tighten the screw to hold it. WeedEater string pull repair STRING WON'T RECOIL ... ? 6:35 ...

starter cord will not move, appears to be locked. is there a release somewhere? no release gonna have to loosen pull cord mount to see if jammed or something broke inside,when you get it loose try ...

starter cord, there is a rattling noise as if a nut has come loose. The motor does not kick over. When you pull the starter cord, three things are happening inside; The cord is spinning the spool that

...starter can't turn it over. well its not going to start with electric because the cord is out of it... just take it apart becareful do not pull the recoil out or your in a mess.... but this should ...

...cord suddenly got stuck. Remove the tube that holds the flex-drive shaft from the front of the motor cover.Remove the rear engine cover. Remove the throttle cable from the carburetor. Mark and unplug ...

...starter cord cannot move when pulled If your pull cord is struck it simply means your shaft is stopped make sure your shaft can spin freely with minimal force.. If you disconnect the shaft and the ...

...starter cord. Have had no other problems for 2+ years. What do I do? Thanks You really need to pressure test the carb, this will quickly tell you if the inlet needle in the carb is leaking, if you do ...

...starter to the flywheel  Also check to make sure the dogs are engaging when the cord is pulled. If not manually move the dogs in and out they might be stuck. If not look at the pulley surface to ...