Homelite Mighty Lite Lawn Trimmer  "weedeater runs bogs down" Questions

...Husquvarna weedeater starts, runs and times fine upright but bogs down when I flip it over to edge. Check the fuel tank vent, and fuel lines for air leaks. could also be a problem with carb

...weedeater won't keep running after fuel in squeeze buld has been exhausted I had same problem, and changed diaphrams, but carb will not adjust or run without choke on. I am thinking control module. ...

weedeater is running she start bog down on hi speed and shut off Check the fuel lines for cracks and breaks. This will cause this problem. You could also have a dirty carburetor and/or old carb. parts

...bogs down on high speed Where are the high speed jets adjustments? poulan ppb 330 33cc trimmer .idles but no high speed power. my solution was to remove postage size screen on muffler known as spark ...

...weedeater it is six months old it starts with choke but when you press the trigger it bogs down and stalls you can keep it running if you keep the trigger pressed but if you let off it dies please ...

...weedeater ut2000413. runs but has no power. bogs down. how can i fix fri-st check your compression should be no less than 76 pds. you can try changing your fuel, high octane only, oil mix no older ...

...bogs down and smothers out quits running This could be a number of things. Clogged air filter/fuel filter/carburetor/fuel tank lid breather hole, cracked fuel line or primer bulb, or clogged spark ...

weedeater featherlite 25cc. runs fine for 10 mins, then bogs, dies when you rev throttle, but will idle. Almost impossible to restart, requires alot of choke. will restart after a rest. Acts just like

...bogs down and dies. Sounds like you will need to clean your carburetor. Be sure to use compressed air to blow out all the fuel and air passages. Sometimes you can get by with priming the carburetor a ...

weedeater. It runs, but when I squeeze the trigger it bogs down and dies. I know that the two little screws on the carburetor need adjusted but I can't seem to find the right adjustment ratio. Can you