Gets fire, gets gas, won't run. Spring assisted Gets fire, gets gas, won't run. Spring assisted cranking. Pull cord hung -up before this happened, but works now. HELP! You will need to disassemble the
it wont start,I replaced the spark plug I even cleaned the carburetor Joe try putting some fuel in where the spark plug goes. If it still doesn't fire then proceed to eliminate things. Firstly the air
...trimmer; UT20737 was running this morning, but it would only run for a few seconds then stop. I realized that if I tipped it up, it ran. The fuel line was frayed off in the tank and didn't reach the ...
trimmer setting the timing belt I set the crank pulley with the slot in the mag (shiny) section pointing up toward the camshaft (appeared to be top-dead-center looking thru SP hole). Set the deep hole
...trimmer has been run using fuel not mixed with oil. I am also concerned that maybe I may be damaging the engine using starting fluid. I do not know the symptoms of an engine being run with non-oil ...
my 32cc craftsman weed eater was running fine.when it ran out of gas i refilled the tank and pulled an pulled nothing check spark, ok,an still it wont fire up. thanks for any help. check for trash in ...
...trimmer now starts great. I have blown out all ports on the throttle body and the head. I am at a loss... Seems as if it has to be a fuel issue. Sprayed ether in and it fires mildly but won't run. ...
...trimmer fires up and runs fine for 5-7 minutes and then dies. About 30 seconds after it dies gas starts gushing out from the carb through the air filter. I can see the gas coming up from one of the ...
will not run check fire ok put a new carbuertor on it still won't run looking for some help Hi Frank, The only 3 main things to go wrong are Fuel, Fire and air. If it's firing ok with a spark and you ...
has new carbuerator an getting fire but will not run plug file out real easy Is it getting fuel?
36 questions posted
Usually answered in minutes!
778 Questions
175 Questions
129 Questions
92 Questions
66 Questions