17" 32cc gas weed wacker 17" 32cc gas weed wacker craftsman model number 358.79925 I need fuel line routing from primmer bulb too tank & carb? Hi pmbaugardne... Please take time to rate me
...32cc weed eater wont start. Push in the primer bulb and it does not refill, stays stuck in! Check the fuel lines for cracks/breaks. If they are o.k., then: You willneed to disassemble the carburetor ...
carb on my craftsman 32cc weedwacker primed some gas and it flows through just fine but gas doesn't seem to get into the carb. I can add some gas directly into the carb and it runs til that gas is
...32cc with Zama carb. the smaller diameter tubing goes to the primer bulb into the tank, the larger from the tank to the carburator. The size of the nipple that the line fits on should also help in ...
...32cc Craftsman weedwacker difficult to start then only maintains idle for anywhere from a couple seconds to a few minutes only when at half-choke, then dies. Will die immediately when switched choke ...
...32cc craftsman weedeater. I have rebuilt the carb, actually two carbs. I have replaced: Fuel tank filter Fuel lines Carb kit Removed plugged screen in carb Replaced primer bulb Cleaned and blown out ...
...32cc craftsman weed trimmer. Cut the end of the line at a sharp angle. Spray WD-40 on the line and fuel tank hole. Slowly screw the line in the tank far enough so you can connect the fuel filter if ...
Question about Craftsman Garden
...line) goes from the left nipple of the primer bulb into the fuel tank. completing the purge circuit. This info pertains to the Craftsman 32cc with Zama carb and may work on the 25cc model as
...32cc starts right up but as soon as i give it gas it stops...help The low side carburetor adjustment screw needs to be turned counter-clockwise. Start by turning it 1/4 turn then test run. If your ...
916 questions posted
Usually answered in minutes!
1,998 Questions
1,006 Questions
710 Questions
285 Questions
244 Questions