...compressor type 30 is not unloading. Auxillary valve seems to be dirty with oil and at 150 psi the compressor is not unloading. It sounds like the pressure switch is bad or out of adjustment. ...
Question about Ingersoll Rand Air Tools & Compressors
...Ingersol rand Rottary Compressor Model# PX6683U06083 Compressor it releases coolant out of the air intake I belive it was running backwards for a short while now it is rotating the right way, can you ...
Question about Air Tools & Compressors
...compressor that wants to start loaded, if I release the load it fills up and then cuts off with out going to unload and then when it calls for air it try to start loaded. How are you unloading it? ...
Question about Ingersoll Air Tools & Compressors
My ingersol rand compressor shuts down on low unload sump check minimum pressure check valve on top of separator cover.
Question about Ingersoll Rand Air Tools & Compressors
...compressor on drilling rig after warm up when l press air pressure button to build up pressure it does not respond well some common problems that compressors stay in "unload" are : (1) a control is ...
again. Sounds like the cutoff valve is failing to cut power off to the compressor drive motor, while it activates the unloader.--- I'd consider looking closely at the contacts, or replacing the cutoff
Question about Ingersoll Air Tools & Compressors
...unloader port should only unload the compressor head, so there is a valve leaking in the system, probably where the fitting that the unloader valve tees into and that also takes the compressor head ...
...compressor, it's call the unloader valve. If this isn't opening the motor will draw much more amperage than it should to start the compressor and it may not even be able to start it at all. When the ...
Question about Ingersoll Air Tools & Compressors
unloader There are two types of unloaders used on IR compressors. One is oil pressure controlled, and second is manually activated for starting. According to the photo and model number provided, yours
Question about Ingersoll Air Tools & Compressors
...compressor is not unloading { going above 120psi} you need to check the air signal going to the unloader valve located on top of the screw, it should start putting out air at about 90psi to close the ...
10 questions posted
Usually answered in minutes!
69 Questions
79 Questions
34 Questions
24 Questions