Question about Northern Industrial Air Tools & Compressors
...valve that opens when the motor kicks off to release the pressure in the compressor itself. That is normal, and is required so that the motor can restart next time without having to overcome that ...
Question about Northstar Air Tools & Compressors
...release valve pops open before it reaches full pressure. It's supposed to hold 140psi but is only getting up to 90psi before it pops. You need to replace the pop it valve with a preset on. they are ...
Question about Hitachi Air Tools & Compressors
...hold pressure. As soon as it airs up the pop value releases releasing all of the pressure. I've replaced the pop value and it did not fix it. There should be a pressure regulator set to a certain psi ...
Question about Air Tools & Compressors
...hold that when shut off. couldit be a check valve? If it were the check valve, (safety release valve), you would hear the air escaping from the safety release valve. You have an air leak somewhere. A ...
...hold a release valve on the air compressor on the engine block for it to build air. and if i let go it makes a pop noise.. Either the interstate saftey is bad, or the valves are. I would start with a ...
Question about Ingersoll Air Tools & Compressors
...release 30psi before it will hold the air in the tank? If at this point I don't immediately switch the compressor off at the wall, it will continue to release 30psi after cutting out then start again ...
Question about Northern Industrial Air Tools & Compressors
release pressure, only when pressure switch malfunctions and allows pressure to reach up to 160psi. The tank will hold over 300psi so dont worry about the 160psi safety. I am not sure about your exact
...release ? ..the switch is new ...but doesn't work like when the compressor was new...any help would be appreciated ...pete Before you adjust the perssure switch, make sure that the intank check valve ...
...release valve). pressure drops until it kicks back on, will not hold air. keeps on cycling on and of? I believe you have a faulty pressure switch. The black hose reports to the switch what the ...
hold pressure pretty good. But, after use has decreased pressure to the cut-off point where it should kick back on, it does not. Well, it turns on, but strains to turn the piston. If the unit does not
15 questions posted
Usually answered in minutes!
69 Questions
79 Questions
34 Questions
24 Questions