in the header. See where the pipes go into the heater, once you remove the cover plate, youll see where the temp sensor wires go into the header, remove the bolt holding it in, and it slides right out
...no problem. If you can't swear a lot. These are for shipping so you don't need to replace them all. Remove the pump and pull the wires or unplug from main box. You can take this to a pool shop or a ...
...bolt with a 3/8" head with a phillips insert. Once you remove the bold the band should come off. Be sure to take note how the light comes apart. You'll have to line up the top screw with the top of ...
...top rempve from the heater so I can get to the blower and check it? I see no screws or bolting to remove it. Thanks. Not the blower! It's the Thermal Bypass located where the inlet and outlet pipe ...
...down. On the rear of the water manifold block their is a eye shaped piece held in with two bolts. Remove these bolts and the plate comes off and will have a brass or steel rod coming from it and a ...
Question about Waterway Pool & Spa
How do I change the Waterway 48 frame side discharge to the opposite side? You should be able to remove the pump housing and rotate it 90 degrees or 180 degrees. Then replace bolts and see if your ...
18 questions posted
Usually answered in minutes!
337 Questions
104 Questions
92 Questions