We are able to start it but not able to get the water to circulate and come thru the wand. This is a portable power washer and only about 4 years old and used very little. When we started it this last
The engine shuts off when the wand handle is released the engine shuts off when the wand handle is released. Could be that the idle is not high enough or there is a problem with the by-pass valve.
Didnt get manual for ortho poison ivy tough brush comfort wand Need to know how to attach and work the ortho poison ivy tough brush comfort wand read the owners manual
...assembly apart and inspect also remember that if a piece is missing look down the barrel of the wand likely it will be a piece of ruber stuck in the end of the ...
...Most weed killers and fertilisers either crystalise or turn to gel when left unused. Pull sprayer wand to pieces and run hot water through the hose and wand, they especially clog up at the spray
...hose to the gun -- hose end is broken off. What is this called and where can I get one? The spray wand has a short plastic tube that the rubber hose slides over. Here's what it should look like, if ...
...comes from Northern Tool. You can't replace the trigger, but they sell the replacement spray wand here and it's only $11.99. There are other wands, some longer, etc. They are pretty universal
...has come loose or has a leak near the top. instead of fluid being pushed up the dip tube into the wand hose the air in the tank is just escaping. You will have to remove the wand hose and figure
...at valve handle for broadcast This happens a lot. Sometimes it's just the hose connection to the wand. If that appears to be the leaking spot, remove the band clamp, take off the hose, and cut off ...
I can not get anything out of the lines, just avery small trickle disconnect the wand at the base wghere it meets the pistol, pull trigger and allow to flow out, reconnet and. also, unscrew end nozzle
4 questions posted
Usually answered in minutes!
95 Questions
11 Questions
8 Questions