smell gas but it does not ignite. If the heater is "acting normal" with no failure codes and you smell gas, then I would bet it's the igniter. The fact that you smell gas indicates the heater does not
Question about Jandy Pool & Spa
...smell gas. All gas lines are opened and inside the unit the the gas switch is turned to on. see if you have 24 volts to the brown and yellow wires on the gas valve if wires are loose it wont work ...
...Shut off the gas valve at the heater and then open the union at the heater. Turn the gas back on till you can smell gas. Shut it down and close the union then turn the gas back on and try it
...smell gas. Turn it off, turn it back on, same thing. Cleaned my filter. I have 15-16 Lbs pressure on the gauge. bet you have a spider web or small debri in the gas lines, take a wire into each one, ...
... Also I smell gas so I turn the gas off and wait 5 minutes and same results. Thanks Hi, The problem is that the hot surface ignitor has gone bad.. replace the ignitor and it will work again. ...
Question about Hayward Pool & Spa
gas smell and it does not light. What can be the problem? first be sure your water filter is clean and the pressure gauge works.....you may need to bleed the gas line to get fresh gas to the unit, you
...but no flame and smell gas. Sounds as though the combustion air is open too far. Try closing it a little, see if that makes a difference. Mark the spot it is at now before moving it. Good ...
Question about Hayward Pool & Spa
...smell a little natural gas when turning on pump, is this normal? pump doesn't show any problems codes. never heard of a gas powered pool pump. if you meant when turning on the heater, this might ...
the union outside the cabinet and turn the gas on till you can smell it. Shut the gas off and tighten the union up again and let the gas clear. Then start the gas and seeif it will light at that point
49 questions posted
Usually answered in minutes!
176 Questions
43 Questions