...reads " water temp short " . Is this a Aqualink reads " water temp short " . Is this a bad water sensor ? This code menad that the water temperature sensor has gone bad. These will cost ...
Question about Jandy Pool & Spa
...Water temperature reads 120 - obviously wrong. Water temperature reads 120 - obviously wrong. Can I disconnect temperature sensor so that water temperature is low and the solar will activate? No but ...
...water temperature sensor reads 155 degrees. Sensor was replaced and it still reads bad temperature reading. Is the control panel bad or is it the PCB in the power center defective? System has been ...
...water sensor that is in a pipe comeing from the pump. But the first thing Iwant to think of is your temp is set on the Aqualink but the temp is not turned up on the heater. If your heater is not ...
...Check this by swapping your air sensor with your water sensor. (Just swap the plugs) if it still reads off then you may need a new board, if this reads ok then the new sensor may be bad. Good
...reads "water sensor opened" Spa heater not working, display panel now reads, "water sensor opened"???? I had the same problem. The water sensor is on a pipe running into your pump. It will have a ...
...water temp sensor on the AL is reading actual temp. Sometimes they will read incorrectly and, for example, display that the water is 142 degrees. If the AL thinks the water is already at or above ...
...water sensor on and 6521 Rev E - What does this mean it either means your water sensor is bad its the little probe thats clamps ontop of pvc with the probe inside of it, or it simply could have been ...
246 questions posted
Usually answered in minutes!
193 Questions
170 Questions
177 Questions
72 Questions