...the 2 safety shutoffs & the Hi temp, Still have the same issue regardless if switched to Spa or Pool. Pressure switch remains closed aswell, So this is not causing the issue. change the assembly ...
My Jandy Laars Natural Gas pool heater (LJ250N) My Natural Gas pool/spa heater keep cycling on and off during the heating cycle. Five minutes on and then 2 or 3 minutes off. The pool/spa gets to the ...
Question about Jandy Pool & Spa
...pool pump cycles on and off instead of stayi I have an Aqualink RS6 system everything works fine in all modes with one exception. When the outside air temp drops and activates "Freeze ...
Heater pops when heating on low cycle I have a Teledyne-Laars natural gas, 125k BTU pool/spa heater that pops quite loudly on the low pump cycle. It does not pop on the high cycle. The heater works ...
Heater was cycling on and off and now wont cycle on. How do you tell if the thermostat is out of calibration. is this a millivolt or electronic ignition?
ags lite comes on gas heater comes on, cycles turns off, comes on cycles turns off and "service ags " message comes on check flame sensor
...pool heater constantly cycles on and off.. it turns off after running about one minute, and then starts the cycle again.. constantly. I have a new combustion blower, new thermostat flow valve and new ...
pool heater cycles off and on raypac versa, electronic . cleaned filter and tryed by pass on pressure switch but problem persists. Heater was neglected and full of leaves and rat droppings but that ...
my laars lx cycles on and off then shuts down. Error code AGR How fast does it cycle? If it is quick like less than a minute the unit is not recognizing the flame. Could be bad flame sensor, bad ...
34 questions posted
Usually answered in minutes!
193 Questions
170 Questions
177 Questions
72 Questions