Sta Rite 1 Hp Above Ground Pump Ne641 "removing impeller" Questions

remove impeller nylon impeller to be removed to check water flow problem How do you replace and remove impeller on outboard Honda 75 motor

How do you remove the motor from a Flotec FPS5172, 1-1/2 HP. Have a Flotec FPS5172 1-1/2 HP. Removed the pump body and diffuser, then removed the 4 nuts holding the motor, but still can't remove the ...

impeller shaft broke at impeller. moytor started to make loud noise . removed end of pump to find impeller at bottom of housing. i have the wsame problem. A new pump will run me 550 I dont think I ...

How to remove the impeller from a Masport Onga HJ200 pump to access and replace the seal between the pump and the motor. The impeller is screwed on to the motor shaft; to remove it you need to hold ...

pondmaster 1800 is slowing down pump is clean of any debris it is approx 3.5 yrs old runs 24/7 Change the brushes in the motor.If its running 24/7 then thats your problem. This is from Danner: SERVICE

the pump does not work after power cycling The pump does not work after after power cycling. To make it working again, I disconnect the power, push the rotor to rotate a little bit. After that when I ...

execetive 56 4hp pump how to remove the impeller left or right thread Looking at the face of the pump, the impeller unscrews by turning it counterclockwise. Also, for some strange reason, the 4HP pump

...screw by REVERSE (clockwise) direction. Then expose the opposite end of the shaft by removing the rear cover to secure the shaft under the points. Turn the impeller in the counterclockwise

...impeller. After removing the face plate, try sliding a screwdriver into the front of the motor thru the vents. You should be able to seize the armature from turning by doing this. Then use a large ...

I have a Waterways 3.5hp pump that I am trying to remove the impeller from. I can lock the shaft but the impeller will not turn off by hand. Is there a method or tool to assist in turning off the ...