Jacuzzi MAGNUM POOL PUMP 1-1/2 HP MAGNUM PUMP BY "capacitor" Questions

...talking about general troubleshooting here. Usually with this size of motor 1Hp. Check if it have a capacitor, commonly if this humms the capacitor is faulty. It is a capacitor start motor. Another ...

...fine, quiet. It will start on it's own again if you do not allow it to come to a complete stop. Capacitor, starter or motor? Just started yesterday. capacitor maybe hard to tell must be check but ...

...on my flotec pump? Thank you for posting your question here on Fixya.com. Using a DMM with a capacitor setting or an analog meter set for Ohms. With an analog, you should see the needle

...it sounds like the pump may have to be replaced. Is this a MQ3-35??? If so, it is most likely the capacitor. This is easy to replace. Take out the 4 screws from the push button cover. The capacitor ...

Pump runs but motor doesn't spin not bound can turn with screwdriver? Is there a capacitor on the motor normally under these symptoms and the motor is a single phase motor the capacitor is defective.

...after a an electrical power failure in the neighborghood. check thermal overload reset. check capacitor, if capacitor is bad, it wil run after a little help with startup. when you open the pump ...

where can I get a new capacitor for a grundfos mq3-45 pressure booster pump the capacitor is a 30uf 250vac 60 hertz 5%toll with a temp range of -25 to 70 degree C Hi try a internet search for farnell&

the pump is bound up but it is more likely the motor is failing. It may be a small part such as the capacitor or the starting switch, but could also be more severe such as the winding itself. You will

replacement instructions How do I replace a 1.0 HP motor top mounted capacitor? Good day, this is John the Hayward tech. I have given you a link to the Power Flo II owners guide. You will need to ...

...reset. push start button and strange humming noise for a short period then kicks out. could it be a capacitor its probably the capacitor,if your lucky that is,if the motor bearings are freezing up ...