Hayward Navigator Pool Cleaner "sweep" Questions

The Hayward Navigator pool sweep does not move. The pressure is 7.5, the suction seems to be okay, and the "flippers" move, but the pool sweep just sits there. You may need to replace the pads on the ...

just bought a new sweep because old one didn't move....this one still very slow, any ideas? This could be an air leak, a partial clog in the line, a clogged impeller, a clogged filter or an ...

How do you adjust the rear tension flap on the pool sweep on a hayward 925 Below is the instruction manual for these pool cleaners. There are diagrams and detailed instructions included in the manual.

...AND BLOSSOMS IN POOL. There is a 5 min. delay on this sytem once you turn on the heater or pool sweep. During this delay you cannot turn off filter pump. Hope this

I have a hayward navigator pool sweep and the hoses keep curling around eachother hampering the operation. What is the cure? Ther hoses retain memory belive it or not try putting the hose on the pool ...

Have a sandman filter and having problems with dirt piles in pool. I brush and sweep vacum nothing is helping. Pump runs good water is clear as a bell. Please tell me what I can do to get rid of these

My Hayward pool sweep gets stuck when it goes over the drain at the bottom of the pool It could be worn shoes on your pool cleaner causing the problem, but it is most likely just that you need to get ...

my hayward navigator pool sweep does not move. we have replaced feet and flaps. . . . . The first question would be do you have the proper amount of suction to make it work. You didn't say if you ...

I just bought and installed a new intelliflo variable speed pump and now my Hayward pool sweep does not move to the shallow end. It only cleans the deep end and even that is not cleaned well. It seems

...it worked as expected allowing air/gas to enter only when on "light" and through the LO to High sweep. Step 1) Shut off gas and remove tank. Step 2) Remove the black gas On/Off knob (pulls off) ...