Pentair Whisperflo 3/4 Hp 115/230v "switching 230 pool pump" Questions

...switching between 115 and 230 volts this is a selector switch this very easily forgotten about. Please make sure to check that and double check that to make sure its on the proper selected switch. ...

replace on off switch on hayward sp2200 Looking for diargram or instrcions to replace bad switch Copy following link for hayward manuals ...

hayward multiport switch is leaking from bottom You will probably need to replace the o-ring. It is a fairly common problem with these pool pumps.

...devices in the circuit to be rated 230 and change the voltage selector on the pump motor to 230 and you are good to go. Examine the markings on your wire insulation to find the voltage ratings. ...

...pool pump installed it and the only thing it will do is hum. OUT THE BACK SIDE OF THE MOTOR IS A SLOT IN THE SHAFT FOR A SCREWDRIVER , SEE IF YOU CAN TURN THE MOTOR OVER(BREAKER OFF !) YOU MAY HAVE ...

I have a new C48K2N143B1 that I'm replacing the same model that has quit. It came configured for 230 and I switched the tab for 120. Wired everything the same as the old motor and it keeps tripping ...

...pool pump runs correctly with impeller attached on the bench. When installed, it also runs fine until priming is completed and then it keeps sporadically tripping out every second and restarting from ...

...230 to 115 besides switching the arrowed connector? Also why does the arrowed connector not go on properly when trying to switch to 115? What do you mean "...not go on properly..."? When moving from ...

switching my hayward pool pump from 230v to 115v. I was told i could just move the jumper, line up the arrows for 115 and be fine but my gfi keeps tripping out? Setting the pump for 115V wont by ...

...pool pump runs correctly with impeller attached on the bench. When installed, it also runs fine until priming is completed and then it keeps sporadically tripping out every second and restarting from ...