Troy Bilt, Tuffy, Rear - Tine Tiller, 4.0 Tecumseh Engine "3hp" Questions

looking for manual for norlett 3hp when pulling the pull cord ,it does not engage the little conter wieghts have catch tabs to engage a hub. sticking springs are causing this problem spray some wd40 ...

my briggs and stratton 3hp edger it wont stay gunning it will run for about 1min it will stay running with the choke on but when i turn it off it dies. i have cleaned the corroborator and it still ...

for mtd 3hp 2cycle motor only stays running when pushing prime repeatedly on full chock 5 sec This is usually a symptom of blocked or partially obstructed metering passages in the carburetor. ...

Briggs & Stratton 3hp engine Flymo won't spark/start My Briggs & Stratton 3hp engine Flymo rotavator won't start. I bought it second hand and it DID work then but I didn't use it straight away

hi I have a easyspin wizard rotavator model no ac3502 it has a briggs and stratton 3hp engine mounted on it there is no spark i have removed the flywheel to expose the points and there is a wire ...

...new carb where do i get one or is there a rebuilding kit and what is its number. techumse engine 3hp Here is a website that will tell you where to look for your particular engine number and how to ...

...and i wondered if the points where set at the right gap . the engine is a briggs and stratton 3hp 127cc engine. i have allready checked the plug and it is fine. thanks very much mark The points ...

I have a craftsman 917298231 tiller, that has a 3hp briggs and stratton motor. The problems seem to be that it is not getting any fuel. The motor will run for a short time when gasoline is poured in ...