...hums, it is trying to run. Try giving the stator help getting started while the motor is humming. Use a small piece of wood or soft plastic. Any non-conductor will do. Look inside the rear of the ...
Question about Hitachi Air Tools & Compressors
small fitting that attaches to the top tank. Unscrew the top nut its about 11/16's, with no pressure in the tank, and make sure the black rubber seat inside slides in and out of the spring loaded cap,
Question about Craftsman Air Tools & Compressors
...small valve on the side of the pressure switch) or tank check valve. If you bleed the tank off all the way and it starts fine, one of these is probably the problem. When the compressor pumps up and ...
Question about Craftsman Air Tools & Compressors
...start. Motor burnout is possible if it keeps recurring. This small release valve is attached to the Pressure control switch that switches the motor On & Off and usually has a small pipe going to ...
...hums when u turn it on it will either trip the 20 amp breaker or it wil start up most of the time it trips.is it that the breaker is too small or something else.please help. Could be a couple of ...
Question about Dewalt Air Tools & Compressors
...start compressor the motor will only hum I had the same problem. Replace the motor capacitor. small white cilinder part with two wire plugs conected to it. This will have a single bolt holding it to ...
Question about Porter Cable Air Tools & Compressors
...start. Motor burnout is possible if it keeps recurring. This small release valve is attached to the Pressure control switch that switches the motor On & Off and usually has a small pipe going to ...
Question about Craftsman Air Tools & Compressors
hums when you put power to it. Your compressor is most likely made by Campbell Hausfeld. The oily substance could be leaking from the capacitor on the motor. Remove the cover and examine the capacitor
Question about Craftsman Air Tools & Compressors
...start. Motor burnout is possible if it keeps recurring. This small release valve is attached to the Pressure control switch that switches the motor On & Off and usually has a small pipe going to ...
small tire stem pin and a lever to engage it somewhere on the pressure switch. If the compressor stops before reaching set cutoff point, the air pressure remains in the discharge hose not allowing the
24 questions posted
Usually answered in minutes!
35 Questions
30 Questions
27 Questions