Dewalt Cordless drill/driver kit 9.6 volt 3/8" DW926K - 2 "bit comes loose" Questions

bit comes loose, check to see if the collar is still lined up at the same place relative to the baseplate. If it is, the chuck pieces are slipping inside; perhaps the transmission setting is incorrect

...not clamp the bit in a vice and using a soft face hammer strike the end of the driver shaft to release the bit. Note: dismantle the chuck over a cloth in case the balls fall out so you don't loose ...

bit. Finally got it loose using some grips to hold the drill steady. Now that piece is out, the nose will not rotate to tighten or loosen the jaws that hold the bit! Is there any steps I might take to

...bit comes lose, when inserting the bit, I held the outer ring - felt the "click" that means it is tight. Started drilling, and drill bit slid inside drill , reset it, drill bit came out of drill and ...

...bit comes loose. Every time I tighten it it loosens again. On this particular tool, you can't really tighten the bit in the anvil like a bit in a drill chuck. The bit is free floating but held in ...

...loose and the screw bit holder will fall out. I have stopped using this drill since it was too frustrating and I woild like to fix it. I bought it as a tool only for $99 so if fixing it is more than ...

...I had the exact same problem. After using the necessary security bit to crack mine open, I found that the large capacitor inside had come loose and needed to be re-soldered. That fixed my

...holds screw driver to use a drill bit. Instructions? Turn your drill speed selector to "1" and put drill direction in reverse. Hold the outer end of the chuck and push the trigger. Should come

bit out of My Makita 6333D cordless hand drill. I usually have no problem. I did tighten the chuck pretty tight, but now can't loosen it. Help. put the drill in a vise and using a pair of channel lock

Hi, The jaws that grip the drill bits jam when closing approx 2mm in and will not close even close to a quarter of the way. Has the bolt that holds the chuck on to the drill come loose? Did the drill ...