chain is properly install but chain won't turn chain is properly installed but turn slowly and won't cut Possible new clutch shoes
a piece of wood is jammed in the mechanism how do I get it out remove the side plate,chain and the bar --- clean and re-install,tighten the chain to proper tension and go back to cutting. c...
Bought new chain for ryobi pole saw attachment still won't cut Make sure the chain is installed in the proper direction.
...installed correctly but when I start to cut the chain slips and stops it is properly tightened and pulls easily by hand You need to inspect the sprocket for wear. Many time the sproket will get a ...
properly out of the box i.e. it does not cut anyrhind at all. after lookin online, I see that I am missing a belleville washer. how would that impact the performance? this washer could stop the cutter
My chain saw (14 inch gas powered) would not My chain saw (14 inch gas powered) would not rotate. I went to Home Depot and the rep noticed that some of the teeth were missing. So, he replaced the ...
...properly threaded along the clutch drum and guide bar, put some tension into it by pulling on the nose of the guide bar away from the chainsaw. While pulling the guide bar, make sure to seat it onto ...
how do I replace the fuel hose to the tank You need to find the proper diameter line as these can vary depending on the model of the saw. I would recommend Tygon line. It is best to feed the line from
Wen replacing all fuel lines on my chainsaw i cant remember wear thay allgo to. Becaus the fuel lines was all britul . chainsaw model is 60015209 ser no; is 11-010955 mcculloch titan 50. Hi kerry, I ...
Question about Poulan Garden
how do I get inside the fuel tank of my poulan 1950 to replace the line in it? To replace line you use tag wire or similar item to pull the fuel line through the tank fittings. First you install tag ...
581 questions posted
Usually answered in minutes!
514 Questions
473 Questions
353 Questions
122 Questions
131 Questions