Husqvarna "Chain Saw - 16" Bar, 3 Hp "gas chainsaw put throttle" Questions

...Spark plug if good shape and put freash gas and oil also the air filter is clean. Hi, bring the hi speed mixture screw out approximately one eighth of a turn and retry. Hope this helps, regards

Chainsaw Will Not Start Will not started First,replace plug,clean filter,use new gas and mixture. push primer 4 times ,put on choke,pull till it sounds like it wants to crank then remove from choke ...

...chainsaw 240 runs then quits when ??? dies at wide open throttle ??? dies at idle ??? dies it restart right away or take an hour or more ??? did you put the right 2 cycle mix in the gas tank

My poulan 3316avx chainsaw won t stay running Put some more gas in it and don't hold the throttle trigger all the way for so long anymore

put the gas mix in and what do i do if i put bar oil in the gas side and gas in the oil side. Its an M S 170 on your stihl ms170 your bar and chain oil goes on the left side nearest to the bar and gas

...chainsaw has spark but will not fire. yes there is gas in tank and i used starting fluid but no go.. Is the plug wet when you take it out ? Is the fire blue and a good arc across it ? I always dip my ...

...put gas directly in tge carb still nothing. Read the warm start procedure from the operators manual. 1. Pull choke (sets fast idle) 2. Push in choke (fast idle retained) 3. Make sure ignition is on, ...

...put the chain saw together as instructed. I added the oil and the premix of oil and gas. Followed the instructions including the choke and pulls. I pulled the spark plug to see if it was fouled. It ...

...chainsaw to disengage the brake. If the chain brake is not the issue, ensure you have good, fresh gas/oil mixture. With the addition of ethanol into fuel these days, small engines take a beating ...

...put a new carb kit in it and a new decompression valve I checked spark and it is getting fuel. I adjusted the jets to one turn out from seat, The throttle is set one turn out also, still won't even ...