Husqvarna "Chain Saw - 16" Bar, 3 Hp "chainsaw starts wont restart running" Questions

...starts,runs good 10 mins. cuts out.wont restart til cold.i suspect coil pack. always the same. Will only start when stone cold.runs perfectly for 10 to 15 minutes working hard then stops suddenly and ...

starts ok runs for about 5mins then cuts out need choke to restart it then it wont run properly If it needs the choke to restart it then there is a fuel blockage, the most obvious place is the fuel ...

...Starts fine and runs great for about 5 mins. Stalls and wont restart until cold. Problem than repeats Try removing the fuel cap for a moment to see it can be restarted immediately. If this works, ...

...wont start. I've heard the magnetos might be the problem but I don't know for sure. I would try richening up the high speed very slightly. If the saw is running a little lean(hot), will make it hard ...

wont start took to local chain saw repair shop they said that because it had water in gas once before the whole motor was ruined but has ran just fine many times since then sprayed wd 40 into carb did

chainsaw starts and runs fine then after about 10 minutes use stops and wont restart, but leave it to the next day starts and runs for another 10 mins. its had a new spark plug,complete carb,tank fuel

...restart it it will not run. You have to push the air purge many times and then it will try to start but wont idle. When I loosen the gas cap there is a big release of pressure. This has only happen ...

homelite ap-125 string is stuck. Any ideas? It started and ran briefly, restarted for a couple of seconds, then froze. Hello, It sounds like you have straight gas instead of mixed gasoline in the tank

...restart and now the engine wont kick round. I assume that you mean it won't run rather than a locked engine. Check for spark at the spark plug. Is it wet with fuel? Is the air cleaner free of sawdust ...

...starts good when its cold,but after you run it , it wont start . I have a poulan chain saw 3400 Check the spark with a clean new plug when it won't start. If absent, then the ignition module may be ...