Husqvarna "Chain Saw - 16" Bar, 3 Hp "chainsaw hard pull start" Questions

...chainsaw 028 that it is very hard to pull the starter rope. If you get it started it runs and cuts great.Why is the starter so hard to pull? Thanks for your expertise answer. Ray Decker ...

chainsaw pulls hard. can't get started Pulls hard, pull the plug pulls easy. Hi Remove the fan housing with the starter mecanism.Pull the starter and check if it works properly.Try to turn by hand the

hard pull start this is anew saw very hard to pull strart The Poulin has a very hi compression you need a good harm.

chainsaw is very hard to pull, but easy with sparkplug out. What could be the problem? You are not strong enough to pull the starter when there is engine compression due to the plug in place. Check to

...hard to pull? Saw was running fine. After turning off, The handle is hard to pull(pulling against engine compression). Maybe the clutch is still engaged? Sounds like it could be seized. Have you been ...

...hard, and now the cord does not return inside the chainsaw, and neither can the chainsaw be started. I believe motor is fine. Did I strip a gear or something, please advise. Thanks. Bleweagle It is ...

...hard to pull start rope with plug in. It will pull to the first top/dead/center and balk. Could the drive key be sheared causing timing to be off ? yes. will it eventually pull thru with the plug in? ...

craftman chainsaw model 530-038044 Want start and crankes hard. changed gas and cleaned filter. has only about 6hrs use. Try pulling the plug n putting a few drops of oil in it n give it a few pulls.

hard to pull runs well after started The flywheels are keyed on the Husqvarna chainsaws, there is not way to change the timing. I would suspect you may have some carbon build up causing the hard start

...chainsaw pulls hard even with plug removed Worked fine yesterday, pulled fine a couple of pulls today, but litter ally the brakes went on and it was tough to pull. Removed plug and pill start and the ...