Toro Lawn Mower With Toro Power Tools "leaf blower bog down" Questions

...leaf blower bogs down in Run position I have a homelite 26D leaf blower that I can crank it up fine but when I put it in the run position it bogs down and shuts off. I put a new spark plug and fuel ...

...leaf blower bogs down. I have the homelite model #UT08107. It starts fine but after a few minutes of running it bogs down when i give it gas. Solution? I don't mean to over simplify this, but are you ...

leaf blower bog down new plug and clean air filter finished. will not run high revs - it just bogs down. any ideas? Likely dirt in high speed needle valve(H); could be leaky fuel line(air leaking in),

leaf blower run and warm up before throttling up and still it bogs down and shuts down. There is no air cleaner to clean should I just blow out the carb. and fuel lines? It runs and idles just no high

why does my leaf blower bog down under acceleration Just a shot.Look at the exhaust and see if the end of it screws out with a socket. If it does, clean the excess carbon thats on it and reinstall it.

...blower tuff starting and bogs down, and dies Cleaned (blew out with compressor) carburetor, replaced fuel filter and lines. Starts cold, bogs down and dies. Have to wait to try and start. take the ...

...leaf blower I can adjust the idle speed but once i give it gas it boggs down and stalls Hi This is either a clogged muffler or carb. Take the off and see if it will rev. If not you need to clean carb ...

blower runs at idle then when you give it gas it bogs down until it shuts off try to choke it part way and see if it still bogs down, if it does then check your exhaust screen, if partial choke helps ...

...blower starts to bog down and then will sputter off. On those occasions that I do get the lever from the start position to the run position and keep it running when I then try to advance the throttle ...

leaf blower has worked extremely well but just today was bogging down while running in the higher speed, seemed like a fuel flow problem to me. In checking out the problem it ran perfectly when I held