Craftsman 20 Hp 42" Deck Lawn Tractor "connect double battery tractors" Questions

...Double check that the (+) connection is correct and tight. 17 Connect the (-) cable [with tape] to the (-) battery terminal [with tape]. 18 Double check that the (+) connection is correct and ...

...the problem what would cause this problem Double-check the battery connections to make sure they are not reversed. Also, make sure the ground wire (and all others, too) are nice and clean and

...battery is dead The ignition switch is bad or a wire has been scraped and is shorting out somewhere. Double check your light panel chassis and other positive-connecting wires to make sure one hasn't ...

...double checked all the battery conections, all are tight, good ground connection to motor ? Please let me know. samvet90. Did you ever figure out what was wrong. I hahve that same problem. Chris If ...

battery is not new but with the direct start it turns over at the right speed. This a 4 year old poulan pro 42" See if there are any fuses or relays on the switch that may be limiting the current flow

...battery terminals for corrosion. Low voltage systems are very sensitive to poor connections and the amperage will not flow to the starter motor. Double check to make sure that the cables are on the ...

battery is good, last replace key switch, because it would seem like you had to wiggle key around to crank, now it wont crank at all... maybe starter? or wiring? You replaced key (ignition) switch? ...

not turn over double check battery connections, if good problem is battery. If you have a neighbor who has a voltmeter/multimeter ask them to check your battery voltage. If really helpful, please rate

...double check). connect to the heavy wire on the starter. Vice grips or a friend will do ok. Then touch the other end of the wire to the + on the battery. (remember the spark). If does nothing, you ...

up. what is the problem? double check the ground wire going from the battery terminal to the engine...it is usually on a mount bolt at the engine...if the mount bolt is loose, it's a poor connection..