Intex 2500 Gallon Sand N Sun Pool Replacement Filter Pump Only "remove air block pump" Questions

...that case, the fittings attached to it can deform and cause bigger air leaks, which compounds the problem. If you replace the fittings, reconnect the pipe and remove any blockages, you should be

...air bubbles in the return water stream going back into the pool. His fix? Remove the antifreeze port plugs, remove the old Teflon tape, replace with new Teflon tape, then replace the plugs. It sounds ...

...remove the lid to your pump where you empty the debris from the basket. Get a hose or bucket and fill that resevoir with water and get the lid back on as quickly as possible. Turn on the pump and it ...

...air in tubing and pump. If it still doesn't turn on, remove outer casing and confirm all filters are not blocked, no build up, etc. If you get nothing, come back and hopefully someone can comment on ...

...pump, open the Air Release Valve on your filter, if you do not have one, open the lid on the pump. There are drain plugs for the pump also, if you have the ability close off any valves so you do not ...

...air lock on the system. The flow switch is fairly easy to replace. You'll probably have to drain the spa unless you have blade valves to isolate the equipment. With the supply power off, you can ...

Just installed a new filter and 1 month old sand from defective filter. Removed the cardboard cover used to prevent sand from going into pipe. Piped everything together and no leaks. When I try to run

...remove the pump lint pot cover..and the strainer if equipted with one..get pressurized air and blow backwards into the low side pool return see if anything may be blocking those lines..sometimes ...

remove the debris bag and observe jet action as cleaner is held near water surface. the action must be strong enough to shoot well into the air. If not, then often a piece of wire can be inserted into

screws on the burner tray remove these and disconect the small pilot supply tube and slide the tray out to clean. use a wire brush lightly and an air compressor to cleat out the burners and the orfice