Husqvarna Lawn Tractor - 54in. Deck, 26 HP, Model# LGT2654 "pulling rear axle john deere" Questions

...tow lever is not pulled out,rear of machine by tow hitch.Also pull rubber caps off of both axle ends to see if one the axles is turning free inside of rim,if so remove wheel and replace axle

...rear tire on a John Deere LX188 There is a plastic small cap (5) in the center of the rim. Remove the plastic cap and there is a snap ring (2) on the axle. Remove the snap ring and the wheel should ...

I need to move it , but very hard to push. Is there a switch or lever to disconnect rear drive axle? in back there should be a lever that is a gold color on most pull it out and it should roll freely

...rear of the tractor over the axle. This is used to move/tow the tractor if the engine isn't running. If the lever has been pulled out, the hydrostatic transmission will not operate. Locate the lever ...

...rear tire off Should be an easy fix....remove plastic dust cap from end of axle... you should see a "C" shaped circlip keeper key in a slot on the end of the shaft with a washer under it...place the ...

...engine dies. Appears to be safety interlock related because the engine will recover if the PTO switch is returned to off. Try a new seat switch,or the rio switch on the right rear of the

...rear wheels others just have a sight plug (two pipe plugs that are directly over one another in side of transaxle) ck at wheel axle shafts for oil leakage (so u know where oil went) also ck for ...

...axle and the pump for tightness. Look closely along each tube or hose for a spot of excessive oil. This could be a hole or cracked line that can suck air. If nothing is obvious then pull the pipes or ...

rear tires.2Place the jack under the frame at the front of the mower. Raise the mower up and place the jack stands under each side of the frame. Lower the jack until the mower frame sits firmly on the

...rear axle. Depending on what it is doing is how you determine what is wrong with it. If the seat switch is bad it won't crank over and if the lift switch is bad it won't crank over, and I am not ...