Question about Craftsman Garden
...I pulled the transaxle out and disassembled and can not get the shift forks to move freely. All gears look OK but teh shift fork will not move witho I disassemble the axle and the shift fork will ...
...gear shift on fender , i suspect the gear shift got hit and bent a bit as this happend to me , you need to remove gear shift heat with propane torch and rebend to not rub the inside , you can see it ...
...gear i shift to it stays in first.Its turning going into transmission because I felt it when I try to shift it. a lot of the murray shift on the fly mower use a pulley system make sure the pulley is ...
...shift into another gear. So far it always ends up shifting but it doesn't go on the first try. The tractor is only 3 years old If you have a manual transmission, all the manufacturers pretty much ...
...shift into gear I cannot get the transmission to shift into any gear. This is the manual transmission (need to stop with brake before shifting) have you removed a rear tire recently? If so, you may ...
...shift even R. just happend. Is very very hard to put in gear or take out running or not but will still run fine after u get it in gear.Can u help ? thanks ron and sandy i would check the shift handle ...
Question about Mtd Garden
...hard to shift gears. It is a 12 hp. 6 gear mower about 20 years old. Could it have an object jammed inside the shifting arm or it could actually be bent just enough over the years from wear and
shift . I had my older model Murray riding lawn mower apart . It shifted ,but sometimes didn't go into 3rd gear . It's the trans with the grease and it was gunked up pretty good . I cleaned it and put
...Gear shift lever is tight and hard to move even when the clutch is depressed. Is the gear lube in the trans-axle low or is there an adjustment for the clutch/brake pedal thanks gerry If the shifting ...
...shift out of gear to neutral or to another gear. If I shut down the engine then I can shift out of gear. I removed the rear wheel and inspected the brake pads they are intact with no oil or grease on ...
342 questions posted
Usually answered in minutes!
529 Questions
514 Questions
473 Questions
353 Questions
122 Questions