...quot;Chain Saw - Describe your Husqvarna "Chain Saw - 16" Bar, 3 Hp Problem Wont start, havent got a manual Remove the spark plug and test for spark. If ok, try some starting fluid in the ...
...chain. cuts at an "angle" "crooked" to the "left" etc. etc. etc. Why? The normal reason for a saw to cut to the left, or right is because the cutters have been sharpened ...
...quot;-is that engine oil (if so, what do you recommend) or chain saw oil (if not, is there another chamber for chain saw oil I'm not seeing?) The mix fuel mix is 40:1. Use Husqvarna 2 stroke oil not ...
...chain bar gear. The "spring steel" strap that is supposed to hold the large gear in apparently lets the gear slip to the outside so the gears do not mesh, and the chain does not move. The ...
...quot;Chain Saw - 16" Bar, 3 Hp Problem my 440e wont run at full throttle. starts and runs at idle fine A couple of things too check here, remove the air filter and clean, remove the spark ...
...quot; chain saw. It is abot 20-25 years old. 40:1 is the ratio for modern saws so I expect it's the same for the older ones. Use good 2 stroke oil like Husqvarna or Stihl brands rather than the ...
All I want is an owner's manual for my Poulan All I want is an owner's manual for my Poulan "Wild Thing" homeowner chain saw (about 6 years old). go to wwwpoulan.com
...chain saws they are small and pain in the *** to work on every time I endulge seems something else goes wrong with it, I dont mind the bigger things(lawn mower engines etc.) but not weed wackers, ...
...quot; bar + chain stalls under load, removed chain and bar, Saw runs fine ? It is running lean, they always need to run a little on the rich side free running, once the engine is loaded it will then ...
...chain saw. I made some adjustments on the "High,Low,Idle" screws. Saw ran beautifully. Idled down once throttle was let go. Full throttle ran great. Second day looked at the saw again, ...
546 questions posted
Usually answered in minutes!
583 Questions
457 Questions
255 Questions