Poulan Wild Thing 2375 18" Gas Chain Saw 2.5 Cuin "chain saw stopped running" Questions

chain saw wiil not stop chain in ideal how do you adjust brake when my poulan wild thing cain saw runs in idal the chain will not stop clean the clutch bell out with a air compressor or somthing

...and not to much pressureon the blade when cutting, let the saw do the work. Also, if your chain is dull or blunt, it will get very hot and need frequent adjusting. Hope this helps you out a

unit works but chain stops when pressure applyed, what oil goes resevior. Does the motor continue to run when chain stops? Electric saws usually don't have a clutch, so I would look for badly-worn ...

chain stops, then you need to take a look at the clutch and sprocket, check them for wear and breakage. If the saw is incorrectly tuned ( running too rich or too lean ) the engine will die in the cut,

come loose. with the chain on the saw and the saw not running, pull the chain around the bar, does the chain mesh with the drive gear correctly? If not, you got the wrong chain or the gear is worn out

...chain was conected to the saw, i think you will see the sprocket is buggered and as that is attatched to the clutch drum that will have to be replaced along with clutch springs and shoes, i think you ...

...SAW IS RUNNING FINE . WHEN THE CHAIN STOPS AND THE ENGINE IS STILL RUNNING AT HI THROTTLE THE CLUTCH MAY BE WORN AND SLIPPING. PULL THE CHAIN AND BAR AND SEE IF THE CLUTCH HOUSING IS BLUEISH IN COLOR ...

chain saw starts and runs chain is moving at high speed but when placed against log it slows to a stop and does not cut, what should I do Remove the clutch cover, bar, and chain. Wash out the interior

...chain keeps on going. Could it be the clutch? your carburator is gummed up. Get some carb. cleaner additive for your fuel, run a couple of tanks of treated fuel through the saw and it will be

...saw and check the chain in that areaaround the clutch, there is probably something holding the clutch back.  Check the safety stop bar as well to see if it has stopped the chain, on newer saws ...