...bar, and chain. Find area where oil is discharged from case--is any part of the rubber seal damaged? Next, use compressed air to clean sawdust and dirt from oiler ports in rear of bar as well as the ...
...bar/chain. Clean the engine side case where the bar fits to and run the engine for a few moments--oil should ooze out of the side port in the engine. If ok, then clean the removed parts including the ...
Question about Husqvarna Garden
...chain. bar is clean but oil dosent seem to get to the chain bar oil leaks or urns all over but dont seem to get on chain. ooil comes out of saw where its suppose to but it dosent seem to get on the ...
...bar. The chain picks up the oil and carries it all the way around the bar lubing it and the chain. When you quit running the saw there is still a lot of oil on the chain and all away around the chain ...
...bar & chain is. I'm not sure which one it is. It is a Craftsman 14 inch chain saw. Remove the bar and chain, then remove the excess oil and debris. Start the engine and look for oil oozing out of ...
...bar and chain. Clean the engine side case where the bar fits. Does the oil port itself leak or is it coming from the engine case? If from the case, it may be a loose or split line from the tank or it ...
bar and chain from the engine. Clean the entire area where the bar fits to the case. Start the engine--oil should ooze out of the side port only. If ok, clean the bar drive-end small oil-channels that
...chain and bar chain and bar no or very little oil ,chain and bar getting very hot quickly. the underneath of oil tank/engine area seems damp with oil hi there i had this problem check bar studs make ...
...bar and chain. Clean all parts exposed including the bar drive-end small oil channels that feed oil out to the chain groove on both sides of the bar. Start the engine and look for oil oozing out of a ...
bar and chain and punch out the blockage in the bar with a paper clip if the chain is removed. Make sure the wire can be pushed from the bar slot right through the side hole in the bar. A gravity feed
546 questions posted
Usually answered in minutes!
583 Questions
457 Questions
255 Questions