pro 38cc 90days old starts fine but wont stay runing Try adjusting idle screw big one w/ spring on it.Clockwise 1/2 turn
chainsaw and is there a special tool you need it just wont idle Most poulan chain saw have three screws idle, high, and low.. if you look air filter cover you will usually see three holes and the high
...wont start i have a poulan 35cc chainsaw i had to replace control module and still wont start it is getting fuel and spark Does it have good compression? Is the muffler plugged? Is the spark plug wet ...
wont stay running. it idles kinda high. stays running with the choke on. pull the trigger 2 giv it gas it dies. Check the fuel filter, air cleaner, and muffler for plugging. Check the fuel lines for ...
...wont idle ..runs fine at full throttle If it runs good at full throtte its the carburtor it needs to be cleaned . Drop the float bowl clean the needle valve its the one that the floats make move up ...
wont idle on low revs first change the plug and the filter in the gas tank. If problem persist try setting the air fuel mixture. I would recomend letting a pro do this setting you could get the mix to
...wont run poulan chainsaw won't run unless on choke all the time. replaced all fuel lines, put new carb kit in, put new fuel filter on, replaced fuel cap, replaced spark plug. Just won't run when you ...
...pro mac 850 in good shape last year. i cut 4 loads with it but i could never get it to idle or wind out like it should. where should i start my tunning. this saw has been modified for ''hot saw'' ...
wont start getting spark and fuel is the spark plug super wet when you take it out if it is you could have to adjust the idle screws to restrict the flow of gas a little because it is getting too much
49 questions posted
Usually answered in minutes!
583 Questions
457 Questions
255 Questions