RYOBI CTH 1202 does not charge Check the output of the charger with a voltmeter. The nameplate shows the output voltage expected. If it checks ok, the battery is defective.
...all the lights work n light up when the trigger is pulled but the motor doesn't do anything voltmeter measure on switch ? 1 of the 4 electric field contacts is broken , or carbon brush has an ...
...das not stay on is it my charger or is the battery the problem thank you ilone If you have a little voltmeter,check to see if charger is putting out 20v DC. If not,try another battery? If second ...
...on this drill. If possible verify the charger is working by swapping it with another or using a voltmeter on the plug. If it is, the battery has failed and will not hold a charge. It is ...
...onto the unit and get someone to hold the motor in place just incase the machine starts. get a voltmeter, follow the wires from the switch to the motor and where the wires attach to the motor
trigger not operating drill in any direction on my gsb202re reversable ,speed controlled, 2x speed hammer drill You most likely will have to unplug and replace the trigger or possily replace motor if ...
batteries won't charge Test your charger with voltmeter. If you get reading on meter, then battery needs to be replaced, if you do NOT get reading on meter, then charger needs replaced
...charger internals are defective. Try a known-good battery first, then look into the charger with a voltmeter. The charger should deliver several volts higher than the rated voltage of the battery ...
...it. If it works you'll get 70 to 80% of it's capacity back. Might want to check the charger with a voltmeter to see if it's
...trigger again it worked then it went dead and stayed that way. You can test the battery by using a voltmeter. Set the voltmeter to DC and to read up to 20 volts. If its getting a reading, then the ...
22 questions posted
Usually answered in minutes!
227 Questions
165 Questions
160 Questions
104 Questions