Set your regulator to hold the hose pressure between 90 and 100 psi. Using higher pressure to set the nail will ruin your nailer. Use the depth adjustment on the gun to set how far the nail is driven
...nail gun usually costs? A good-quality starter set, including both a compressor and a small nail gun, can be bought for around 200 US dollars (USD). More sophisticated models can reach 1000 USD or ...
Question about Arrow Tools & Hardware - Others
...nail gun only put nails in 1/8 of inch. I just bought this yesterday so maybe this a defect or is there something I am not doing. I bought this because I am not good with a hammer. keep hitting my ...
Question about Hitachi Tools & Hardware - Others
...nail gun won't set nails into 3/4 trim. I have played with the turn/screw set adjustment and it is set for the deepest setting. This gun was purchased second hand off e-bay but my Hitachi nv65ah ...
...gun. The shorter nail does not give enough resistance allowing the driver to slam against the lower bumper inside of the gun (made of rubber or vinyl) forcing it to compress. There might be a rubber ...
Question about Tools & Hardware - Others
...nail clips feeding, first make sure the entire feed path is clear of any nails, parts of nails or other foreign things. Then make sure the nails you are using are fully compatable with your ...
...gun to allow the nail to be adjusted to how far in you want the nail to go into... this depend on the material you are nailing into... the adjustment is sometimes located right at the point of where ...
...nail shoots. Damages finish alot. Anybody have an idea why? Could it be quality of nails? Also, dial on top of gun back what is that for? The dial on the top of the gun is most likely the depth ...
...gun so its very unsafe. I want it to onlyshoot ONE nail at a time. How can I repair this problem. Thanks, Fritz Most all nail guns can be converted to single fire, however, usually parts must be ...
Question about Hitachi Tools & Hardware - Others
...nail gun will jam if it isn't properly oiled before using. Occasional oiling while doing a big job is a requirement also. I don't depend on an oiler in the air compressor line. I add oil before I ...
87 questions posted
Usually answered in minutes!
68 Questions
48 Questions
33 Questions
58 Questions