Pride Mobility Victory 3 Wheel Electric Scooter "release brake scooter" Questions

...brake does not release 100%, a easy test is to run the scooter then put your hand on the brake unit , is it hot ? be careful because it could be very hot , this will prove the brake is not releasing ...

brake release mode. The battery is charged up? What is the problem? Hi. Has the machine been in regular use before the fault occured? You say that the brake is in brake release mode, this mode is only

...?, Some Sterling's work with the brake disconnected so check the wiring.. remember 24v is applied to the electromagnic brake to release the plates allowing you to move, keep me posted please. ...

...brake release. Is it possible to test the controller. I have some knowledge of electronics. You can check the voltage going to the motors. The clicking you hear is the brake releasing. most likely, I ...

...brake release lever sticking out of the top or back of your scooter on the driver's right hand side. Push this handle the opposite way it is now and try the scooter. If this does not work, repeat the ...

...Brake release switch is off. Check the Park Brake and wiring for open or short circuits. Check the brake connections, the two wire leading to the brake, if the rear motor comes away fro mthe frame ...

...brake release when you push the throttle lever by applying 24v to the brake , if the brake does not click then the brake might be faulty or the controller is not outputting24v ,check the wiring and ...

...a faulty or burn't out motor will cause this fault. Also check that the brake solenoid ( free-wheel )is releasing properly. Can you push the scooter when the brake is released? Good luck.

...release the brakes. Weak batteries will cause the brakes to drag and the scooter to run slow. A new brake costs about $70 and new batteries start at $40 each. If you do not have a beep fault code, ...

...brake release lever is not working by this I mean the lever will not move the release position, this could be a case of the brake mechanism has seized up due to water or that sand and grit has got in ...