Golden Technologies Avenger 3 Wheel Electric Scooter "motor brake work mobility" Questions

...motor and brake to get it to work properly. The brake can stick or drag causing the scooter not to want to start up. Ride the scooter for a while and feel the rear of the motor near the brake (be ...

brake doesn't hold.The motor brake works fine when trying to slow down, but the brake to hold the scooter stationary does not Hi... Sounds like a bad brake linkage Contact Pride 1-800-800-8586

...motor dose not work I have a simmerler problem On my scooter the electric/magnetic brake got wet and the brake corroded stuck and the wires to the brake had come off. I'm now searching for a ...

motor/brake. There is a connecting rod from the brake lever to a ball that can be pulled up or down where it exits the back cover. The connecting rod and brake lever may be bent making it difficult to

...Try driving the scooter a short distance and feel the motor case at the rear near the brake assembly if it is very warm or hot the the brake is sticking and will have to be replaced. Hope this ...

motor casing near the brake assemblies on the rear of each motor if the casing is hot then you have a sticking brake pad or pads and this can cause the excess battery drain. If you have sticking brake

...brake. The motor starts to get hot there and around the brushes but the brushes are in good condition. Any ideas would be appreciated. Cody yep that could be the problem. When you engage the throttle ...

...brake off the motor but do not disconnect the brake wiring. The scooter looks for that connection to work if it can't find the brake then it will flash and won't operate. now if you do hang the brake ...

...the motor and the magnetic brake because the the motor and magnetic brake that was on the scooter got very hot The eelectronic controller needs to be checked. All motor current passes through

...like it is at the motor. Error 9 possible Solenoid Brake Trip The parking brakes have a bad connection. Check the parking brake and motor connections. Make sure all the system connections are