...Check the obvious battery Remove spark plugs and try, make sure engine is not mechanically bound or seized. Check the starter motor to make sure it isn't binding ...
Question about Generac Guardian Electrical Supplies
When I try to start it it clicks than nothing. Any thoughts? What you are describing is the symptoms of a dead battery, bad or loose cable or perhaps a seized piston.
...control could be damaged, governor out of adjustment or internal throttle butter fly shaft stuck/seized
Question about Briggs & Stratton Electrical Supplies
...do If the engine is locked, it could be any one of several things. Most are rather expensive, like: seized due to no oil; broken rod; bad valve, etc. An engine mechanic is going to have to ...
Question about BlackMax Electrical Supplies
...the motor/engine). If the pull cord will not turn it could be because the motor/engine is
Question about Coleman Electrical Supplies
I have a coleman 1850 that I cannot pull the start cord at all check to see if the cord is knoted up in the pulley. if not you either have a seized up engine or armature.
Question about Briggs & Stratton Electrical Supplies
...5 seconds of run time The bearings on the alternator, or the end bearing on the engine, is likely seized. Engine tries to overcome, but ends up shearing the key. You might also be using the wrong ...
Question about Generac Electrical Supplies
generac 4000xl runs a few minutes then acts like it's seizing up Eeeeeeek! Thats not good! Sorta like a grinding sound? If it's under warranty take it in! Might be the "winding" where the electric is ...
cord wont pull It seems like the engine is seized, it may not be too badly seized. Try taking out the plug, if necessary take the end cover off the alternator, and see if you can put a wrench on the ...
162 questions posted
Usually answered in minutes!
4 Questions