...pot. Move the speed pot while pushing the lever forward. If it works could be the speed pot has a dead spot on it. Also check wires loose and a mechanical issue with the throttle pot and the
...check the spped control pot and the throttle pot. You will need a ohm meter to check both pots Usually replacing the speed pot will help but it could be both speed and throttle pot Hope this ...
Question about Health & Beauty
...check the resistance marked on the original speed and throttle pots, with the new ones. Generally a throttle pot is 5Kohms and 20 or 200 ohms for the speed pot. when you installed the throttle it was ...
Question about Health & Beauty
...throttle lever must be checked for cracks in the middle, which release the pressure of the setscrew on the pot shaft. also the return spring may be broken, which would cause a similar situation. ...
Question about Health & Beauty
...may have internal wear spot, or a broke wire to the throttle. If someone were to check the pot they would look to see that the resistance moves evenly when activating the lever. Scooter Doctor ...
...throttle pot fault and seed pot fault. I have tested the throttle pot with it in the center position I read 2.5k and when rotated 5k then back the other way 0k. I have also tested the speed pot i am ...
Question about Shoprider Health & Beauty
...check that the throttle pot that is attached to the throttle lever is not loose , if it wobbles about that can be a indication that the throttle pot is worn and when you go in reserve its not giving ...
...throttle pot as well too. Check under your tiller where your throttle is there is a little pin hole ,This pin hole is right in the middle of your your throttle arm, this set screw that hopefully is ...
throttle pot. me tool time you checked or changed about everything but did you check the electric brake. Sounds like the brake is not working or is working intermittentaly. The controller needs to get
Question about Pride Mobility Products Health & Beauty
...is: Throttle control fault. 1. Check wiring for open/short circuits. 2. Check the throttle set-up.... The ohms should be very close to each other when placed checking forward and reverse on set
20 questions posted
Usually answered in minutes!
42 Questions