Coleman Powermate Powermate 5000W Generator "switch 5000 watt" Questions

...5000 watt Homelite Generator will start on the first pull but then runs for about 2 to 5 seconds and dies or it gets rough and then dies. I have cleaned the carburator and checked the full line for ...

...5000 watts with 10 horsepower Briggs and stratton engine and I cannot start the engine after an oil change; there does not seem to be any spark at the plug when I try to start it. I do not have the ...

...to shut down/off, please tell me what to do. run a wire from the plug to theframe and put a switch inline and that way when you turn the switch on it will ground out the ...

no spark Hi, Check the on/off switch is set to on. replace sparkplug check magnedo. Good luck.

How to fix a genset 6500 generators that stops when you turn starter switch loose? Check the oil level or any other alarm that can stop it. The switch may have lost its middle stable position and drop

GE Generator 10kw model #040448. TRANSFER SWITCH FAULT message being displayed. Generator works fine. Generator output load voltage = 233V. This generator has a built in transfer switch. If you do not

...5000 Watt Devilbiss gas generator. It's 10 years old. I would like to install a transfer switch in my home and there is an issue. There are four standard receptacles on the gen set - two 120 V / 20A ...

...5000 watt, on and off switch located on top of the motor. is there a wire thats supposed to hook onto the switch somehow. Kill switch should have a wire connected to the tab on the spark coil under ...

...bleeding, good battery. Will not start even with starting fluid. mmost engines have a low oil switch. if generator is not level or it is low oon oil by just a little it will not start hope this ...

...switch mounted on the rope pull housing on the coleman 5000 powermate 7500 watt unit. You can't get the housing off without removing the start stop switch. without seeing it, they usual have enough ...