Coleman Powermate Powermate 5000W Generator "open oil fill gas" Questions

...OPEN the fuel shut off valve when you think you would like to start the engine.) If you should have this happen again DO NOT try to start the engine! (That's one of the reasons The Da always said, ...

...than top up the recomended oil secondly check the air filter it should not be clogged clean it drain the old gas from the fuel tank if there is any fill it and do not open the choke and try starting ...

oil level fill fuel tank with fresh fuel open the shut off valve on the bottom of the tank put choke on and turn the kill switch to the on position and pull the rope release choke after i second pull

...open the fuel line it starts leaking from a hard black rubber next to the carburator remove the filter and look down the tube if the carb is filling with fuel then the float needs adjustment or ...

open. You might want to tap it with a screwdriver to see if it seats or shake the generator a bit. If that doesn't work you'll have to remove the carburetor, take out the float bowl and manually check

...open generator back cover, try to see the condition of generator iron (stator and rotor).Check the bearings. Check the oil (level and condition, it may have water or gas in it).   Take out the ...

...oil, and fresh gas. Sound`s like your not gettimg fuel. 1 take fuel line loose from carb. (have a bolt handy to plug gas line unless the gas is old then drain gas into a suitable container for ...

...oil and fill as needed if low if good then it should be a 1 wire sensor remove the wire and crank see if there is a spark if there is then that unit needs replacing you can run the engine with out ...

oil and new spark plug The carburator may be empty. Open it and fill it with fuel before starting. Other way is to get a starter spray, open the input collector or where it is possible and spray while

...oil to the brand new Genset. 1 - Some Genset gas tanks come with a gas cap "blocking insert" under the gas cap that should be removed according to your manual if it states this. (Read manual section ...