Question about Electrical Supplies
generac 4000XL. engine dies when idle control switch is thrown. I have a generac 4000XL. Starts and runs fine, UNTIL I throw the idle control switch to ''on''. When I throw the switch, the engine dies
idle problems Please rank this answer, Carl Another possibility would be that the muffler is clogged preventing exhaust flow ... Remember one-cylinder four-stroke technology is basically: 1. **** ; 2.
Question about Porter Cable Electrical Supplies
This is for the Porter Cable H650IS-W-1 Contractor Generator. It has an idle/RPM control solenoid that adjusts to the load on the generator. I can see that the solenoid works because 9VDC applied to ...
Question about Kohler Electrical Supplies
...Generic trouble shooting from the service manual: Engine Will Not Idle 1. Dirt or water in the fuel system. 2. Stale fuel and/or gum in carburetor. 3. Faulty spark ...
Question about Electrical Supplies
My Makita G5500r power generator doesn't have smooth Idle? I bought this generator many years ago. When first started, the low idle was smooth. When power was needed, motor speed increased and ...
Question about BlueStar Electrical Supplies
my miller blue star 185 wont idle up when you start welding it wont idle up under a load the solenoid was changed Check your idle control module, take the roof off of your welder, located at the top ...
...a signal whenever current is drawn thru either wire. The current transformer sends its signal to an idle control circuit on a printed circuit board inside the control box. The other wires from this ...
...problems, aprx 8 yrs old and not used a great deal until hurricane Ike came thru here and it ran for several days with minimal down time. Afterwards I changed the oil (replaced with honda oil) and ...
my honda 1000i sputters when at low idle what could be the problem? i cleaned the carb and made sure there was no blockages. if i leave the choke on at half it idles good. I cleaned the air filter and
when idle down switch is turned on you can see the solinoide move the govenor lever to idle down but too much so the engine shuts down. how do you adjust the idle down? Hello, generally there is a ...
849 questions posted
Usually answered in minutes!
549 Questions
64 Questions
57 Questions
47 Questions