...idle speed, then rev back up to regular speed when you draw current from the generator. To check it use the DMM to measure the speed at startup ( should be 61.5 Hz), when it idles down (about 37 Hz), ...
...speed and then idle down or does it start at idle? If it starts at idle, or seems to idle down faster than usual, something might be amiss in the works. 2 - When you turn the idle control switch to ...
...speed would like it to idle down when not powering anthing Most generators will run at full speed when started. Verify in the owners manual if Your generator has an idle control setting. Even so, as ...
Question about Northstar Electrical Supplies
...speed. Check your idle solenoid by applying 12Vdc. If it moves then the solenoid is fine. This means you will need the idle control board, or in most cases the idle board might be integrated with the ...
...larger load. Any suggestions? Throttle motor or control box? Idle speed screw may need adjusting slightly to increase idle speed. Also Main jet and Idle mixture Screws may also be out of ...
idle at a low or normal speed it does not deliver enough power to run things properly. Now my question is I'm not sure if my unite has auto idle or not apon futher investagation I discovered that what
Question about Coleman Electrical Supplies
...idle when there is load on the generator it has idle control. I could not understand, it doesn't go in low idle when load is connected or no? It should go to low speed idle with load under 20 - 30
...speed up under a load stays at idle.give it gas at the carb. by hand and it will run a power tool ect. Thanks You most likely have a problem with the Automatic Idle control circuit. I suspect the ...
Question about Electrical Supplies
...idle and 150v at operating speed. new control board #96476, new power regulator #92769 still same results. is engine running at 3600 to 3700 rpm at full load. most small engines run at this speed.you ...
...idle but only puts out proper voltage under load when it is manually adjusted for engine speed. The linkage to the carb is ok and throtle on carb works fine. I posted an answer to a similar question ...
55 questions posted
Usually answered in minutes!
38 Questions
22 Questions
14 Questions
15 Questions
11 Questions