Sony BDP-S350 Blu-Ray Player "power unit" Questions

...unit from A/C power. Hold in power button, plug unit into wall whilst holding in power button for 10-15 seconds. If that doesn't reset unit, then simply hold power button in for 30 seconds whilst ...

power button on the unit for 10 seconds, The unit powers off then back on. U61 error message appears on screen. This means the unit is carrying out its recovery process. This process restores the unit

...POWER ?/I] on the main unit to switch the unit to standby. If the unit doesn?t switch to standby, press and hold [POWER ?/I] on the main unit for about 10 seconds. The unit is forcibly switched to ...

...DVD Power} to switch the unit to standby. Now press (power, DVD POWER) again to turn the unit on. If you don't have the manual handy see web page ...

...power.. The unit was flashing on the display screen 9 something it usually does not do). i could not switch on or off the unit using the remote or the actual buttons on the unit. After turning the ...

...unit this is the power supply area, If you have indicators lit or the display is coming on then the unit may have a bad power supply or the System control board has failed. It which case its cheaper ...

unit. The power supply used in this unit is below quality and is often the cause of power not getting to rest of the unit. The company is from china and does not have a usa warranty service since they

...does not keep the power on to the unit when you let go of the power switch, then the unit goes into shut down mode. Then the unit will display good bye. I would have the power switch looked at

...unit from the power source...If I had waited a little longer before repowering the unit, I wouldn't have had to send the unit in (obviously the unit was without power during shipping and when it was ...

...power on. This unit must have a power supply board in it where power enters from the mains. A capacitor, fuse, diode, etc may have been defective on the power board and maybe that's why its not ...