fuser has failed and needs to be replaced. If it is still under warranty Brother may cover it. If not you will have to take it to a Brother Authorized service center. It may be possible to find a used
...printing. Screen says fuser cover is open. Where is it located so I can close it? Your problem: paper is jammed in the back of the printer around/in the fuser. The Users Manual for your printer is ...
...that are hanging down from the cover. Also, make sure your drums are installed in the proper spots (magenta in magenta slot). If the toner "rubs off" after it prints... then the fuser is
Question about Samsung Office Equipment & Supplies
...fuser, closed the doors (but did not replace the right side cover). When I turn on the printer the display switches between "ready to print" and "door open". When I press print it says not available. ...
Question about Samsung Office Equipment & Supplies
...fuser, closed the doors (but did not replace the right side cover). When I turn on the printer the display switches between ready to print and door open. When I press print it says not available. I ...
Question about Brother DCP Office Equipment & Supplies
...printing, as it says there is a paper jam In tryting to fix our fuser problem and removing the fuser, someone tried to print as we were putting the fuser back in. Now the printer won't print anything ...
...saying jammed, now paper gets crumpled and ink smears on one side when printing. What should be done? Sounds like the teflon film on the heater assembly has torn. This is not an uncommon problem but ...
Question about Brother DCP Office Equipment & Supplies
...that the printer was set for "duplex" printing (left over from a previous document). Duplex is incompatible with auxiliary tray printing, and instead of saying so, it just gives the "paper"
...fuser cover and it refuses to print I have turned the power off, unplugged it, taken out the ink cartridge/replaced it, removed the paper sliders and still I get a red light and the above messege. ...
...cover up and pull the paper tray out as well. Carefully remove the paper you find and reassemble. Hi, U can do the below steps but it will best if u call an engineer to the job:- You see the access ...
162 questions posted
Usually answered in minutes!
422 Questions
374 Questions
395 Questions
242 Questions
245 Questions