Pioneer TS-W307D2 12" 1200 Watt Champion Series Subwoofer - 2Ohm Car Subwoofer "hook 2 car amps together" Questions

...positives together and both negatives together and bridge it to the amp. if it is one channel hook it up as one together. if it is 2 channel hook positive to one side and negative to the other

...2. Then hook the wires to the amplifier. To bridge the amplifier (if it is a 2 channel bridgeable) would be to use the left positive and the right negative, but check the amplifier for markings to ...

...hook up a 15" solo baric L7 to a2400w cx 1200.1 kicker amp The CX1200.1 amp is 2 ohm stable. Hopefully, you have the 4 ohm DVC version of the Solo-Baric L7. If so, connect the DVCs in parallel (both ...

...would you hook a alpine r12 dual 4 ohm sub to sony xm-1s mono amp in parallel get both positives and both negatives together and wiring them to amp for a 2 ohm load. the sony xm1s is a 2 ohm mono ...

...2&woofer_imp=3 On one side of both woofers positive (+) and negative (-) are connected together. Then you will need to hook the remaining + terminals together and go to the + of the amp. Then you ...

...hook up two 10 inch subs and 15 inch sub a kicker 250.1 amp Series or parallel? Single, dual voice coil? I'm not sure you have the right size amp for all 3 speakers. And I wouldn't wire the 10's ...

2 sets of RCAs into the one set. Also it doesn't really matter how you hook the RCAs up unless you are going for stereo sound then you would need to make sure the rights are hooked up together and the

...hook each 2 ohm speaker separately to the amp one to one side and one to the other. What is the best way to run 1 of my speakers and the best way to run both of them. Somebody please help ...

amps are 1,2,or 4 ohm so i suggest going 2 ohm. The amp should be rated for 800-1200Watts @ 2 ohm load for this sub to work properly and make sure that amp is at max 80% by adjusting gain.This website

hook up 2 4ohm subs to it easily But both channels are actually connect internally together in parallel inside the amp unlike a 2 channel they are separate. So just connect your mtx 9500 to a plus and