...using? this is a sure sign of chain overheating , due to not enough oil to bar , this will eventually cause bar to wear down and chain to not stay on ck your oil pump and oil tank for proper ...
...SURE IT OILS THE CHAIN. IF THIS DOESN'T FIX - REPLACE THE CHAIN. IF IT STILL HAPPENS THEN REPLACE BAR. WILL FAIL AGAIN WITHOUT OIL. POULAN WILL NOT HOLD UP WITHOUT CHAIN LUBRICATION. WORSE THAN ...
...bar but you should check the manual to see what gap is recommended. If the chain is blunt and overheating, it can expand and become loose rapidly. The slack in a chain should be taken up in any case ...
...bar, is starting to show signs of overheating and the chain oil supply is working properly. We also made sure that the chain tip was greased and the guide bars were greased. The minute we starting ...
...cover oil, was flowing out. Would the chain have overheated and seized? ARE YOU SURE THE KICK BACK BAR IS NOT ENGAGED , IF YOU HAVE PULLED IT BACK VIGOROUSLY AND STILL HAVE PROBLEM IT IS PROBABLY
bar vertical surface so that they don't catch on the kerf cut. Make sure the chain is being sharpened and adjusted properly. The 'choking down' may be from the engine overheating while trying make the
...so that you don't have to force the chain into the cut which causes motor overheating. If you need to make an 'under' cut, do so with the top of the bar--don't run the saw upside down. Good
...is wide and untidy and the saw seems to pull into the log Take a close look at the groove in the bar where the chain runs and the track on which the chain sits on the bar. If there is any ...
Question about Makita Garden
...come loose that fast , and is not a cause of a weak bar bolt slipping , for sure is caused by improper oiling of chain and its overheating , heat makes metal expand so chain goes slack if it gets ...
368 questions posted
Usually answered in minutes!
155 Questions
148 Questions
117 Questions