Behringer Pmp3000 16 Channel Audio Mixer "amp 2 power pin" Questions

Ad

...2 and 3, and the inputs for the amp section outputing on pin 7 are pin 5 and pin 6.  If you get sound at pin 1 or pin 7, you move forward to the next TL072.  Check for output.  Then ...

Ad

Question about Peavey Music

2 Answers

2 to power trafo. Power ON the amp. If fuse is not blowing,PDCH and PACH circuit is good and all tubes heater/filaments are lights after a few seconds. If fuse blowing,there are parts is damage (dioda

Ad

Question about Behringer Music

1 Answer

...amp 2 Pinout Diagram Hi, I want to repair my V-amp 2 power supply and I need the pinout diagram. Where I can find it? Thank You! Don't have the pin lay out but the power supply is a transformer with ...

...2 channel amp. Very carefully... SInce the outputs are not specified as isolated, your speakers would be connected across the hots and the returns would be jumpered. Then for the two inputs you would ...

...2 pin and 3 pin cheers 7815 and 7915 plus and minus regulators specifically. Diodes fr the 15 supplies are 1N4001 but you can use 1N4007 or anything in between. Big power rectifiers are 2504's... ...

...2 & 3 are inverted (3 is HOT), but you got British here, they switch the HOT pin on the XLR to pin 2. That means that if you run this unit with US speakers your signal will be out of phase. Be ...

Question about Behringer Music

1 Answer

...pin is the live and neutral for a behringer dx 1000 pro mixer On the power line cord the neutral usually has a wider blade. Also the cord MAY have ribs on the side of the neutral conductor. The ...

...Amp 2, 4 pins Hello Robotek. I have a question for you on this subject http://www.fixya.com/support/t624729-replace_4_pin_plug_behringer_v_amp2_psu , if I could also spread thisdivision into which ...

Question about Music

1 Answer

...power. Too small an adapter might cause it to light up but will not operate the unit. The correct adapter should say AD12 on it. It is a 2 volt, center pin minus, and probably 1 or 2 amps capability. ...

Question about MXR Music

1 Answer

...2 diodes after the power input be likely problems? I can also swap out the IC chips for tl082 and tl084s if this is ok. I'm not sure actually if these ICs will work properly due to the higher power ...

Not finding what you are looking for?
Behringer Pmp3000 16 Channel Audio Mixer Logo

215 questions posted

Ask a Question

Usually answered in minutes!

Top Behringer Music Experts

Cindy Wells

Level 3 Expert

6688 Answers

Brad Brown

Level 3 Expert

19187 Answers

john h

Level 3 Expert

29494 Answers

Are you a Behringer Music Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...